Velluto in Motion: When a Les Paul Speaks in Its True Voice
Updated: 6 days ago
Daniel Alfassi plays an Epiphone Les Paul Custom fitted with Vergatto Velluto humbuckers.
Gibson's early humbucker
A patent application for Gibson engineer Seth Lover's two-coil pickup was filed in 1955. Gibson started fitting it to Les Pauls in 1957. The "Patent Applied For" sticker on the underside gave those early pickups their nickname, PAF.
The goal was to reduce hum. A single-coil pickup can pick up mains hum along with the signal from the strings. In a humbucker, the two coils face the strings with opposite magnetic polarity. They're connected so the string signals add together while much of the hum picked up by both coils cancels out.
Compared with a typical single coil, a PAF usually sounds fuller through the mids and softer at the top end. Peter Green, Mike Bloomfield and Duane Allman all played Les Pauls with these early Gibson humbuckers.
The idea behind Velluto
Velluto is our take on the PAF, built to the specs of "Greeny", the 1959 Les Paul played by Peter Green and later by Gary Moore and Kirk Hammett:
Magnets: Alnico II in both the bridge and the neck pickup.
Wire: 42 AWG plain enamel, wound by hand.
DC resistance: about 8.7 kΩ in the bridge and about 8.3 kΩ in the neck.
Polarity: standard by default. Greeny is known for its out-of-phase sound in the middle position. If you want that sound, ask us and we'll reverse the neck pickup's polarity.
DC resistance is only a rough guide to output, not a measure of tone. In practice, these specs give a moderate-output set. We aim for a bridge pickup that sounds clear without being sharp and a neck pickup with a warmer, rounder sound. With a little drive, the notes in a chord should stay distinct.
In the videos
Listen to the start of each note and how it fades. When Daniel plays a chord, see how easily you can pick out the notes within it. The clips show how Velluto sounds in this guitar and recording setup. Your guitar, amp and settings will change the result.
Getting the most from Velluto in your guitar
Set the pickup height by ear. Note your starting height so you can go back to it. Adjust the mounting screws a quarter turn at a time, then play the same phrase on the bridge and neck pickups to check the balance.
Use the volume knob. If your amp is just starting to break up, try rolling the guitar volume back a little. The sound can clean up without changing the amp settings.
Check your strings and cable. If your guitar sounds dull, try fresh strings or compare a shorter cable of the same type. A longer cable can soften the highs on a passive guitar.
Try it in person
We wind each Velluto set by hand and check it before it ships. You can try guitars fitted with Vergatto pickups in Ramat Gan or Be'er Sheva, or ask us about Velluto on WhatsApp.



Comments